Is 225/60R16 bigger than 215/60R16?

225/60R16 is 0.47 inches taller and 10 mm wider. In overall diameter that is +1.81%, which stays inside the ±3% rule of thumb for a substitution.

How much will 225/60R16 throw off my speedometer?

Every reading scales by 1.01806. An indicated 60 mph becomes 61.1 mph, and every 100 miles on the odometer is really 101.8 miles.

How much does 225/60R16 change ground clearance over 215/60R16?

The axle centerline moves by 0.24 inches — half the diameter change, because half the extra height sits below the hub and half above it.

Will 225/60R16 fit where 215/60R16 fits?

Nothing derived from the size code can answer that. Clearance depends on wheel offset, suspension travel and body dimensions that no tire size contains. This page tells you exactly what changes dimensionally, which is the part that can be calculated.

215/60R16 vs 225/60R16

225/60R16 is +0.47″ in overall diameter and +10 mm in section width against 215/60R16 — a diameter change of +1.81%, which stays inside the ±3% substitution rule. An indicated 60 mph would really be 61.1 mph.

Within 3%

Every dimension

Difference between 215/60R16 and 225/60R16
Dimension	215/60R16 → 225/60R16	Change
Overall diameter	26.16″ → 26.63″	+0.47″ (+1.81%)
Section width	215 mm → 225 mm	+10 mm (+4.65%)
Sidewall height	129.0 mm → 135.0 mm	+6.0 mm
Rolling circumference	82.18″ → 83.66″	+1.48″
Revolutions per mile	771.0 → 757.3	−13.7
Axle height / clearance	13.08″ → 13.31″	+0.24″

215/60R16215 mm

225/60R16225 mm

215/60R16 26.16″225/60R16 26.63″

Which is taller, 215/60R16 or 225/60R16?

225/60R16 is the taller of the two, at 26.63″ against 26.16″. The gap is 0.47 inches, or 12.0 mm.

Both are metric sizes, so neither states its height directly. Both figures below are derived from the section width, aspect ratio and wheel diameter in the code. 215/60R16 is 215 mm wide with a 129.0 mm sidewall on a 16″ wheel; 225/60R16 is 225 mm wide with a 135.0 mm sidewall on a 16″ wheel.

What the speedometer will read

Indicated versus actual speed after the size change
Speedometer reads	Actual speed	Error
25 mph	25.5 mph	+0.5 mph
40 mph	40.7 mph	+0.7 mph
55 mph	56.0 mph	+1.0 mph
60 mph	61.1 mph	+1.1 mph
70 mph	71.3 mph	+1.3 mph
80 mph	81.4 mph	+1.4 mph

Fitting 225/60R16 in place of 215/60R16 multiplies every speed and distance reading by 1.01806. Over 10,000 indicated miles the odometer is out by +181 miles.

Effective gearing moves by the same proportion. A vehicle with 3.73 axles running 215/60R16 would need 3.80 to keep the same engine speed on 225/60R16. Work it out for your own axle ratio.

Full specification of each size

215/60R16

Derived dimensions for 215/60R16
Dimension	Metric	Imperial
Section width	215.0 mm	8.46″
Sidewall height	129.0 mm	5.08″
Wheel diameter	406.4 mm	16.0″
Overall diameter	664.4 mm	26.16″
Rolling circumference	2,087.3 mm	82.18″
Revolutions per mile	479.1 / km	771.0 / mile
Measuring rim (estimate)	165 mm	6.5″

225/60R16

Derived dimensions for 225/60R16
Dimension	Metric	Imperial
Section width	225.0 mm	8.86″
Sidewall height	135.0 mm	5.31″
Wheel diameter	406.4 mm	16.0″
Overall diameter	676.4 mm	26.63″
Rolling circumference	2,125.0 mm	83.66″
Revolutions per mile	470.6 / km	757.3 / mile
Measuring rim (estimate)	178 mm	7″

Rim widths differ too: 215/60R16 is designed for 6″–7.5″ and 225/60R16 for 6.5″–8″. Their measuring rims differ, so the same wheel will not be ideal for both.

Can you swap one for the other?

Inside the ±3% rule

The diameter difference of +1.81% is within the ±3% that fitters use as the boundary for a substitution, so the speedometer, odometer and wheel-speed-derived systems stay close enough to calibration. The section width difference of +10 mm is a separate question and is the one that decides whether it rubs.

Neither figure says anything about physical fitment. Whether 225/60R16 clears the strut, the fender liner and the steering stops depends on wheel offset and suspension geometry that a size code does not encode. For maintenance rather than sizing, Car Basics covers tire care.